Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Trinity, NC

Holmes Garage Door Garage Door Cable Repair in Trinity, NC

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

Holmes Garage Door Garage Door Cable Repair is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Frayed, snapped or slipped lift cables replaced and the door re-leveled. We work on Holmes Garage Door garage doors of every age, from older models to current lines, and carry or can source compatible parts.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for Holmes Garage Door garage door cable repair

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

What usually causes it

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

What you can check yourself

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our Holmes Garage Door garage door cable repair process

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

How much does Holmes Garage Door garage door cable repair cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Holmes Garage Door services

Serving Trinity, NC and nearby towns

Humid air in North Carolina rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Besides Trinity (ZIP code 27370), we handle Holmes Garage Door garage door cable repair in Archdale (1.7 mi), High Point (4.3 mi), Thomasville (5.2 mi) and Jamestown (7.6 mi). Call (833) 435-8883 to book a visit in Trinity.

Holmes Garage Door Garage Door Cable Repair: frequently asked questions

How much does Holmes Garage Door garage door cable repair cost in Trinity, NC?

Holmes Garage Door Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Holmes Garage Door garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Holmes Garage Door garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Holmes Garage Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where North Carolina or Trinity requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Trinity, NC

Broken Garage Door Spring Repair

Fast replacement of broken torsion or extension springs, sized to your door's weight.

Typical $200-$450

Wayne Dalton Off-Track Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $175-$450

Raynor Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Hörmann Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Richards-Wilcox Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Ryobi Garage Door Opener Installation

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $350-$800

Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Janus International Roll-Up Door Repair

Janus International is a major maker of roll-up doors for self-storage facilities.

Typical $150-$600

Haas Door Garage Door Installation

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $1,200-$4,500

Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Trinity, NC now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote